1/12/2024 0 Comments Kitchenaid blender leaking![]() Before removing the grease, make sure that it's the cause of the leak by inspecting it for signs of separation. It's normal for the grease to be a dark color as long as it hasn't separated. ![]() Remove the Old Grease from the Mixer The mixer gearbox will have a large pile of grease in it. Lift the motor housing straight up to pull it off the gear shaft and away from the mixer. The front end of the motor housing is actually part of the mixer's gearbox that attaches onto a gear shaft, so it will still be partially secured onto the mixer. With the housing screws removed, the rear cover off, and the strain relief disengaged, the motor is now free from the lower half of the mixer. Pull the motor housing off the mixer stand. Take note of which screw has this washer, as the screw must be returned to a rear fastener position on the motor housing. One of the two rear housing screws in one of the two rear-most positions will have a retaining washer on it. There are also four rear housing screws that similarly join the mixer stand and the motor housing-these also must be removed with a flat head screwdriver. ![]() Remove these five screws with a flat head screwdriver. Removing the planetary exposes five screws that hold the mixer's motor housing to the stand. Then, pull it off the rest of the way by hand. To start, pry the planetary off a little with a couple of flat head screwdrivers. The planetary can now be removed from the mixer. Using a pin punch and a hammer, tap the planetary pin out of its place. The planetary shaft pin is the last thing holding the planetary to the gear box. Tap the planetary pin out of its pin hole. Use a flat head screwdriver to gently tap the drip ring off of the planetary. It is held to the mixer planetary with just a little surface tension. The beauty ring decorates the mixer, helps seal the gearbox, and catches leaking grease. Remove the planetary drip ring (beauty ring). The power cord strain relief will then pull out of the back of the mixer stand. Remove the rear housing cover by unscrewing its one Phillips head screw. The strain relief is located underneath the mixer's rear housing cover. The power cord must be freed from the motor, and that means removing the cord's strain relief. Remove the rear housing cover and power cord strain relief. The first part of the repair, accessing the mixer's gears, requires a little disassembly of the machine. Access the Mixer's Gearboxįixing a leaking KitchenAid stand mixer is a four part process: accessing the gearbox, removing the old grease, adding new grease, and reassembling the appliance. Replacing the gearbox grease can take as little as ten or fifteen minutes with this professional repair advice. Read the steps below for how to fix a leaking KitchenAid stand mixer. To fix the problem of oil leaking out of a KitchenAid mixer, the old grease in the mixer's gearbox must be replaced with new grease. The grease inside the mixer's gearbox can separate for several reasons heat from overloading the mixer, not using the mixer often enough, and time are the most common reasons. When the grease inside the gearbox of a KitchenAid stand mixer separates, the liquid part of the grease can leak out of the mixer as an oil.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |